How To Repair Your Ski And Snowboard Base With P-Tex

How To Repair Your Ski And Snowboard Base With P-Tex

Getting scratches on your base is a
normal part of skiing and snowboarding. Surface level scratches can be smoothed
out with the base grind by a professional tune shop. But deeper
scratches, or core shots, can interfere with your riding and will be a threat
to the health of your skis or board. Core shots will eventually allow water to
soak into the inner layers which can then cause the layers to separate or de-laminate. This type of damage can be the end of your favorite skis. But if it is
caught early enough it can be repaired back to its original strength and remain
on the snow for years to come. You can repair most core shots yourself at
home with the base material called P-tex. P-tex sticks can be found at most ski
shops and it comes in clear or a variety of colors to match your base color. Here
are a few things you’ll need to do this repair; a P-tex stick, a sharp blade, and
a lighter, base cleaner, scouring pad, metal scraper, and a well-ventilated area
where you can make a mess. First remove the excess base material from around the
damaged area using a sharp blade. Then scrub clean the area of any dirt using a
base cleaner. Once it is clean and dry you can light your P-tex with a careful flame.
P-tex can be slow to light. Using a constant flame from the candle or even a
torch is best to light the stick. You’ll need a safe surface to allow for
the hot P-tex to drip while you work. When lit, P-tex is dangerously hot, be
careful not to let it drip on your skin. When you get comfortable working with
P-tex you can make very little mess, but it is
best to be prepared for the worst when starting out. Once lit, hold the dripping
P-tex above the repair area letting the drips fill in the scratches. Hold it low
and close to the area. If it is a deeper repair, it will need several layers of
P-tex to fill in and let each new layer of P-tex cool in the base before
relighting the stick and adding the next layer. Repeat this process until the
layers are built up, filling the entire area. After the P-tex is fully cooled use
your knife to remove the excess material above the base surface. Finally, a metal
scraper will shave the final layer down to evenly match the base surface. Use
careful small scrapes to finish the job, going back over it slowly and evenly until
smooth with your base. There you have it, your base is as good as new. If there is
an extra-large gouge or if it is along the metal edge, it can be best to have a tune
shop do to repair. Even with a repair fee it will be much cheaper than new skis or
a new board. If you have any questions, feel free to give us a call or swing by
our shop. Like this video? Then like it and share
with your friends. Want more? Subscribe to our channel here and visit and sign up for our email so you never miss an adventure.

Antonio Breitenberg

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *